Türkçe   İngilizce
Home
About
Products
News
Services
Certificates
Human Resources
Contact Us
 Quick Access
- Home Page
- About Us
Products
Thermal Insulation Motar
Adhesive Mortars
Joint Filler Materials
Filler Joint
Flex Joint Filler
Flex Pool Joint Filler
Silicone-Based Joint Filler Mortar
Water Isolation Mortars
Ground Application Mortars
Rough Construction Mortars
Primers
Repair And Plaster Mortars
Assistant Coating Products
- Services
- News
- Human Resources
- Contact
PRODUCTS
HomeProducts Joint Filler Materials « back
Filler Joint
1 / 4 Next
1 / 4 Next
 

APPLICATION
Indoors, dry and wet environments, horizontal and vertical surfaces; ceramic and coating material used to fill the joints.

PROPERTIES
Before the application dust, construction, cement residue can be found from joints, should be cleaned with a brush by scrapping off. Joint space if necessary before the application should be moistened with water.

PREPARATION AND APPLICATION OF MORTAR
First water is put into the mixing bowl, then add JOINT FILLER. (6.5-7lt water/20 kg bag) and stirred until all lumps are dissolved. Waited for 5 minutes, to obtain a homogeneous mix again. Prepared mortar is applied with a rubber tip spatula. After about 45 minutes of application the surface is cleaned with a damp sponge. After the first day of application for high-performance surfaces should be dampened.

CONSUMPTION
Joint Range (mm)                 
Ceramic Size (cm)    3 mm (gr/m)      4 mm (gr/m)        5 mm (gr/m)      6 mm (gr/m)     
10x20                           450                     625                    800                    900     
15x15                           400                     550                    700                    850     
15x20                           375                     500                    625                    750     
20x20                           325                     450                    600                    675     
20x25                           300                     400                    550                    600     
20x30                           300                     400                    550                    600     
33x33                           200                     300                    375                    400   

TECHNICAL SPECIFICATIONS
Using time, hour                                                     3
Bending Strength, N/mm2 (EN 12808-3)                    >3,5
Compressive Strength, N/mm2 (ENİ 2808-3)              >15
Abrasion resistance, mm3 (EN 12808-3)                    <2000
Shrinkage mm/m (EN 12808-4)                               <2
Water absorption, after 30 min, g (EN 12808-5)        <5
Water absorption after 240 min, g (EN 12808-5)       <10

CERTIFICATE OF CONFORMITY
The above data have been obtained in laboratory. For more information, please consult our Technical Department. Nanokim reserves the right to change the above information. Nanokim is not responsible for any failure due to misapplication.

Other Products in This Group
   • Silicone-Based Joint Filler Mortar  
   • Flex Pool Joint Filler  
   • Flex Joint Filler  
   • Filler Joint  
   
 
 
Address: Hamitli Mah. Uzuncaorman Sok.No:48/A Hendek / SAKARYA Telephone: +90 850 650 6266 Faks: +90 654 55 00 E-Mail: info@nanokim.net
 
Home | About | Products | News | Services | Certificates | Human Resources | Contact Us | Keywords © All Rights Reserved